+- tost3 (https://www.tost3.com)
+-- Forum: Razors (https://www.tost3.com/forumdisplay.php?fid=6)
+--- Forum: 3D printed razors (https://www.tost3.com/forumdisplay.php?fid=58)
+--- Thread: The Triceratops 3d Printed SE Razor (/showthread.php?tid=267)
Pages:
1
2
RE: The Triceratops 3d Printed SE Razor - ischiapp - 12-20-2020
(12-20-2020, 01:02 PM)Wchnu Wrote: We might have to start a 3d printed razor board.I think It's enough to use the right thread in the right section.
https://www.tost3.com/showthread.php?tid=261
RE: The Triceratops 3d Printed SE Razor - Jayaruh - 12-20-2020
(12-19-2020, 07:40 PM)Ordinaryshaver Wrote: Jim, I watched the video, looks like it was a great shave.
Question, and I hope fuzzy doesn't see this, but how hard would it be to shim this razor?
I don't think you can shim it because the blade indexes down into a slot.
RE: The Triceratops 3d Printed SE Razor - Wchnu - 12-21-2020
(12-20-2020, 08:08 PM)ischiapp Wrote:(12-20-2020, 01:02 PM)Wchnu Wrote: We might have to start a 3d printed razor board.I think It's enough to use the right thread in the right section.
https://www.tost3.com/showthread.php?tid=261
You make a solid point. I will fix it
RE: The Triceratops 3d Printed SE Razor - twhite - 03-03-2021
I just picked up a 3D printer this weekend. First order of business was to print a razor. You guessed it, The Triceratops. What a great choice that was. This razor ROCKS. Design is spot on and performance to match.
Great job to the designer of this.
RE: The Triceratops 3d Printed SE Razor - GAW9576 - 03-03-2021
(03-03-2021, 04:05 AM)twhite Wrote: I just picked up a 3D printer this weekend. First order of business was to print a razor. You guessed it, The Triceratops. What a great choice that was. This razor ROCKS. Design is spot on and performance to match.
Great job to the designer of this.
Looks awesome Tom.
RE: The Triceratops 3d Printed SE Razor - Wchnu - 03-03-2021
Good job there twhite.
RE: The Triceratops 3d Printed SE Razor - Jayaruh - 03-04-2021
(03-03-2021, 04:05 AM)twhite Wrote: I just picked up a 3D printer this weekend. First order of business was to print a razor. You guessed it, The Triceratops. What a great choice that was. This razor ROCKS. Design is spot on and performance to match.
Great job to the designer of this.
Congrats on the 3D printer, Tom. The Triceratops was a great choice. Such a fine little razor.
RE: The Triceratops 3d Printed SE Razor - twhite - 03-04-2021
Great shave. I did notice that after taking the blade out to dry it. When reinstalling it. It was a bit loose. The plastic on the handle that holds the blade compressed some. I just made a .007 thick piece of brass for a shim. Tightened right up.
Just finished printing the ENDGEM I will try that tomorrow.