11-13-2021, 02:36 AM
(11-12-2021, 09:41 PM)srqshaver Wrote:(11-12-2021, 04:18 PM)Old Sarge Wrote: A couple of times the Triceratops unscrewed itself, but I caught it before anything bad happened. Just something I'll have to pay attention to in the future.
Hope everybody has a great weekend!
Hmm. I should have one of these soon so I'll have to keep that in mind. I wonder if there's any way to make the threads a little tighter so it requires some force to turn thereby keeping it from coming unscrewed when you don't expect it. Maybe a piece of plumbing tape would work.
(11-12-2021, 10:16 PM)Old Sarge Wrote:(11-12-2021, 09:41 PM)srqshaver Wrote: Hmm. I should have one of these soon so I'll have to keep that in mind. I wonder if there's any way to make the threads a little tighter so it requires some force to turn thereby keeping it from coming unscrewed when you don't expect it. Maybe a piece of plumbing tape would work.
Hey, Eric!
It wasn't an issue, other than when j-hooking around my jawline. I try to be careful not to over tighten considering the material. To insert and remove the blade you have to unscrew the handle a bit. The blade slides in and then has to rotate upwards so that the tabs on the blade fit around stops. Are you talking about teflon tape? It might work, but might also have to be reapplied. I like to remove my blades from my razors and store separately, so I'm all about screwing and unscrewing!
Have you seen Jayaruh's video? If not, here is a link.
https://www.youtube.com/watch?v=HNcLw8bRkbA
He also has another video showing loading of a injector blade. I believe there are a couple of shave videos with the razor as well. Jim does a real nice job!
A small o-ring between the head and handle may help.