tost3 › Razors › 3D printed razors
The Triceratops 3d Printed SE Razor

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
The Triceratops 3d Printed SE Razor
twhite Offline
Lather Catcher
****
Posts: 464
Threads: 13
Likes Received: 929 in 425 posts
Likes Given: 697
Joined: Mar 2020
Reputation: 355
#18
03-04-2021, 02:48 AM
Great shave. I did notice that after taking the blade out to dry it. When reinstalling it. It was a bit loose. The plastic on the handle that holds the blade compressed some. I just made a .007 thick piece of brass for a shim. Tightened right up.

Just finished printing the ENDGEM I will try that tomorrow.
Lost, If found do not return and do not feed.
The following 2 users Like twhite's post:
  • Dave in KY, GAW9576
Find
Like Reply


Messages In This Thread
The Triceratops 3d Printed SE Razor - by Jayaruh - 12-14-2020, 09:25 PM
RE: The Triceratops 3d Printed SE Razor - by twhite - 03-04-2021, 02:48 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)