Fuzzy Catcher

[Dave in KY]

I carefully taped a sharp injector blade by just the edges to the sharp enders blade being sure the cutting edges were lined up properly. Put JB over the injector AND squeegeed the JB back and forth with an old credit card to get it down into the holes and behind it. Then scraped the access down to be level with the top of the injector. Then carefully removed the injector blade while the JB was still wet.
Once the JB was dry I did a little fine tuning with an Exacto knife. I did not need any release agents because the injector blade was removed while the JB was wet. Also I did rough up the enders blade were the JB would be first to help it grip better. After all is done I removed the entire bevel of the cutting edge of the Enders blade to be sure it would not interfere with shaving in the future.

If I can get a few say 4-6 good heads built next week. I was thinking of letting you guys test them for me. All I ask is you cover shipping and a bit of time.

Please let me know here if you are down with that.

Oh yeah, I'm in if I'm included in "The Gang"