Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Raptor SE 3D Print by Roger Quintero
#12
Ok. Here is the report. You all know what razor. The Raptor. Blade CVS CS new. Tabac for soap and AS. I had a full 4 days worth to deal with. 

Initial first stroke impression. Keeping blade as flat as I could to my face. Very smooth indeed. I did notice not a lot of blade feel. Think Gem FW. I know after that first stroke. This is going to be a nice shave. So I overcame my urge to whip through the shave as of it were a FW. I took my time making deliberate strokes. First pass was an above average pass. 

Second pass went just as well. Third pass went on without a hitch. I had to do a few clean up strokes on my normal spots on my neck. In the old man creases. ZERO irritation and a solid DFS shave. 

 On to things I noticed specifically about the razor. Very easy to load and un load. The clever clamping works great. An extremely maneuverable razor. Outstanding design simply a beautiful tool. I do not mention it being light weight as that goes without saying. This razor will please the majority of shavers for sure. Those looking for a bunch of blade feel. You won’t get that. 

Roger you definitely have a winner. Here is the shave setup. I will post some closeups shortly.

I forgot to mention that is rinses the lather out just fine.


Attached Files Thumbnail(s)
                   
Lost, If found do not return and do not feed.
The following 6 users Like twhite's post:
  • Dave in KY, GAW9576, ischiapp, Jayaruh, mayer57619, SlimGem
Like Reply


Messages In This Thread
RE: Raptor SE 3D Print by Roger Quintero - by twhite - 03-30-2021, 10:58 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)