Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
looking for info on blades for Schick injector razors
#5
(06-20-2022, 07:58 PM)riverrun Wrote: Chicks are the best choice, especially if you are in the US. Be content. Other blades are only marginally better.
Personna blades are OK, but I'm not too fond of their plastic magazines. In the worst-case transfer them to a Chick magazine.
You can't beat them for price and a lot of shavers like them.
Schick Prolines are really good, but not as easy to get hold of and not really cheap. You need to transfer them to a proper magazine as they come in key-less magazines.
Excellent blades though. Well worth getting.
There are Schick blades from Japan, both single and twin blades. Brilliant blades, but these days at eye-watering prices.
You need to order them from Japan.
I'd keep an eye out for vintage blades as well. Anything from 1965-ish onwards is a good bet. Avoid older blades as they were not stainless steel and are usually in really bad condition.
If you manage to get hold of the legendary Personna 74 blades... they are the best. Ever. Good luck getting them for less than $5 per blade. If they show up at all.
Vintage twin blades are great as well, but they are almost as rare as the Personna 74 blades and they usually come in magazines holding two blades only. Which makes them very expensive as well.

TL;DR: Stick with the Chicks.

I was also under the impression that the twin blades only worked in the H and later razors. Is that correct? 
I have some Personna blades from https://connaughtshaving.com/injectorblades.html and greatly prefer them to the sChicks. I also have some 74s and although they are great blades was not personally blown away by them. I'm glad I actually got them for a considerably lower price than they usually go for.
The following 2 users Like GAW9576's post:
  • CDinVT, Jayaruh
Like Reply


Messages In This Thread
RE: looking for info on blades for Schick injector razors - by GAW9576 - 06-21-2022, 03:11 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)